Norsat ATOMControl Manuel d'utilisateur télécharger pdf (Page 25)

3 Controlling ATOM Devices

- 23 -

Software-Based Muting

Software-based muting is controlled by a single parameter that overrides all other muting

controls: the Mute Command parameter. If Mute Command is set to 1 then the ATOM

Series device will be muted. If the Mute Command signal is set to 0 then the device will

be unmuted (assuming it is not muted by hardware or by faults). By default, the Mute

Command parameter is set to 0.

ATOMControl shows all of the values relevant to software-based muting in the bottom-

left groupbox in the Mute tab in the Controls section of the User Interface. The value of

the Mute Command parameter is displayed along with a button that allows the Mute

Command value to be toggled between 0 and 1. Figure 8 below shows the software-

based muting controls:

Figure 8: Software-Based Muting Controls

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Norsat ATOMControl Manuel d'utilisateur Page 25